NetworX – Arming Modes AWAY is a arming mode that is used when the user is away from the premise and wants the interior protected. Listed below are the steps to arm in the AWAY Mode: Step 1 Step 2 • Enter your 4 or 6 digit user code to arm the system. • The […]
Networx – Arming Modes Read More »
NetworX – Understanding the lights Armed Light The armed light is “on” when the system is armed. The armed light is “off” when it is disarmed. The armed light will flash when there has been an alarm during the previous arm cycle. Bypass Light The bypass light is “on” when any zone in this keypad’s
Networx – Understanding the lights Read More »
NetworX – Changing User codes CHANGING USER CODES Step 1 Your system must be in the Disarmed state to change user codes. Step 2 Press [*]-[5].Step 3 Enter a “Master Arm/Disarm Code”. NOTE: For partitioned systems, someone changing the code of another person must have access to all or more partitions than the user being
NetworX – Changing User codes Read More »
NetworX – Setting your date and time It is very important to make sure that your alarm systems date and time is correct. The date and time reflects on the internal logs of the system, and it helps investigators and engineers to identify when a system was armed or disarmed or at what time the
NetworX – Setting your date and time Read More »
NetworX – Alarm memory The alarm memory feature on alarm panels is a feature used to check which zones of the system has gone into an alarm state in its previous arming cycle. Most systems can give you a more in-depth report which is called the event log, which can be accessed with the right
NetworX – Alarm memory Read More »
NetworX – Trouble Conditions KEYPAD CONTROL TONES (BEEPS) A sounder is built into the keypad. If programmed, your system keypad may sound for any of the following reasons: Beeps for all keypresses. The service light will be “on” if the security system requires service. If the service light is “on”, press the [*] key followed
NetworX – Trouble Conditions Read More »
NetworX – Bypassing a Zone All modern alarm system allows you to bypass a zone. If your alarm system does not want to arm because a zone (input is open) is not closed, you can tell the alarm system to ignore the zone and arm the system. The term “bypass” is used if an input
NetworX – Bypassing a zone. Read More »
NetworX Keypad Commands The NX Series features an extensive suite of keypad commands, many of which can be utilized without the requirement of entering a master code. However, access to certain advanced functionalities, such as panel programming, may necessitate the input of the installer code or mastercode. These keypad commands offer a user-friendly interface to
NetworX – Keypad Commands Read More »
NetworX Alarm Systems NetworX The Hills reliance Security System and the NetworX system share numerous similarities, making them two prominent choices for comprehensive security solutions. Both systems are renowned for their reliability, scalability, and advanced features that cater to a wide range of security needs. With a focus on intrusion detection, access control, and home
